Motorola MCU'sPick the Adapter you want to use, attach the flat cable to the Adapter (PIN1 is always indicated, on both the cable and also the Adapter) and also to the main board's 10pin ISP connector. You can also use the included DIL to 10pin Flat-ribbon header, put it inside the ZIF socket and wire up an SOIC clip or clamps for ISP use from there. Insert the correct config key into the slot of the mainboard and start programming either via the ZIF or SOIC Socket.

Simply connect the mainboard to the UPA programmer directly or by using a DB9 male / female extension cable (1:1). (Power from the UUSP to the ISP target can be enabled or disabled by a jumper next to the 10 pin ISP connector)ġ x Mainboard with 40pin DIL ZIF (600mil) socket and 14pin SOIC ZIF (150mil) socketġ x MC68HC11KA2/4 & MC68HC11KS ISP Adapterġ x DIL to 10pin Flat-ribbon header (For using IC clips or clamps) The included PLCC ISP Adapters are to be put directly over the soldered chip of the target device making the work convenient and safe compared to soldering or using clips connecting up all manually. The main Device further includes a 10 pin ISP connector where the included ISP Adapters can be connected using a standard 1:1 flatribbon cable (included). It's equipped with an 40pin ZIF Socket for all narrow and wide DIP / DIL devices as well as with a 16 pin SOIC ZIF (150mil, narrow) socket to cover most commonly used devices.ĭevice configuration is done over special config keys which make the work convenient and safe compared to wiring up all manually.Īdditional packages can be covered by commonly available Adapters plugged into the 40 pin ZIF socket. Upa-usb 2013 is the full set with all adapters,The main Device can be directly connected to the UUSP (UPA-USB Serial Programmer) or by an optional DB9 male / female 1:1 extension cable.

2013 New UPA USB Programmer with Full Adaptors Green Color

Upa usb 1.5